Receivers are made of 4130 moly seamless steel, unless otherwise noted. Each receiver comes with an accurate CAD drawn template bonded in place. All specifications are on the template so that you can check your progress as you work.
Receivers produced by Luna and Diablo's Den are defined as follows:
Blank with Template: CAD drawn template bonded on. All work will need to be completed upon purchase.
50% Completed Dummy: Receiver turned to proper o.d. Rear of tube has been turned down so that end cap will slip fit over the end and can be welded in place. All mill work remains to be finished by buyer. Includes bonded on CAD drawn template.
50% Completed: Receiver turned to proper o.d. Grooves have been cut for rear lugs. All lathe work completed. All mill work remains. Includes bonded on CAD drawn template.
Blank with Template with Lower Receiver Section: CAD drawn template bonded on. All work will need to be completed upon purchase. Lower Receiver Section will replace from the magazine back (trigger group section) and the forward section under the front pistol grip.
G Return to top G
